Instructions

LIMITED TIME OFFER
FREE SHIPPING ON ALL STICKERS

Easy to apply.

Easy Application.

1) Position Sticker with masking tape tabs. (See Figure 1.)

2) Apply a strip of masking tape vertically over one end of the sticker to hold it in place. Remove position tape tabs (See Figure 2.)

3) Remove white release liner (backing) while holding sticker away from the surface it will be applied to.

4) Starting from the hinge slowly rub firmly side to side gradually laying down the sticker onto the on the surface. ( Figure 4.)

5) Rub firmly over entire sticker. Pull up the masking slowly while the sticker stays on the surface. (Figure 5)

6) Remove any leftover masking or tape. (Figure 6)

7) Enjoy your new sticker!

Disclaimer: At no time will Hurricane Press be held responsible for buyer's ability to apply a decal, damage to surface during install, or damage to surface during removal. Buyer accepts that over a long period of time, the area around a decal will fade and when removed, the area where the decal was installed may still be noticed. Buyer accepts that this is a very adhesive material and that damage may occur to surface when trying to remove the decal. Said damage may occur from improper removal or failure of the surface applied. The maker of the vinyl material states that the material should last 5 years on outside surfaces if properly applied. This is a statement from the maker and not any guarantee from Hurricane Press.